Strap Hole Duplicator (no. 30 or 1/8”), long used in the aircraft industry for locating and drilling an accurate hole in overlapping or blind surfaces. Hole to be duplicated is drilled through the hardened bushing when the pin of the pilot is located in an existing panel or support. New panel is slide between the duplicator straps. The duplicator makes it much easier to use a cleco out in a panel surface. No longer is it necessary to use clecos in only overlapped or joggle surfaces. By adding tabs strap duplicators are a great aid in locating panels on bucks & forms. Available in a 6” & 13” reach sizes